Recent content by James also

Coated bullets are mandatory IMHO, unless you like to scrape off lead in the cylinder. As stated Berry's would eliminate that at 800fps. IMHO

Our PPC rounds are less than target velocity. In Michigan the indoor range is 50' and a 600fps is adequate with a light roll crimp for ignition is all that's required. I do mine on the flat just below the top radius. Don't push them they were meant for low velocity's.

How about a voting ballot?

Ya gotta consider the source when dealin with AH's

I've seen similar boxes, Agree!

A 1000$ lever pistol round is a bit much for me. Jus Sayin.

I found an old silverware case for my 1st issue Colt DS snub nose, it has some kind of tarnish retardant, so far so good.

For PPC reworked revolvers, the Federal and Federal match are the standard. I have to dump them from the large tray into a plastic bag, then pour them into the primer flipper tray carefully, Ugh.

When your Wright your Right!

only if its moving!

Great fan of the crimson trace laser grips for out of position instinct shooting.

Musta been the plan, hated to have her beat them!

Rimfires are a completely different animal.

We had that problem with building PPC revolvers. For reloaders the answer was use Federal primers, They are the softest of all primers to ignite

The beauty of hand loading is developing the perfect round. Longer barrel, slower powder!