Recent content by Hole Shooter

Now that's some fine looking gun leather!! You are a blessed man.

VERY NICE!! Thanks for posting. hs

Just wondering if anyone has bought the TandemKross leather holster designed for the Ruger Mark IV? If so, how do you like it?

Contender, I think you may have just solved my problem. Thank you, sir! Actually, I didn't know that I could crimp over the front driving band. After a little research I see that several people have had good success doing just that. Many thanks to you!! HS

Can anyone recommend a good Commercially cast bullet for the Single Seven 327? I have tried both Missouri Bullet Co. and Acme bullets for their 100 grain RNFP coated bullets and both are a little long for the short cylinder Single Seven. I can make them work but I have to crimp forward of the...

Thanks, Kevin. I appreciate the info. I will remember that next time I order bullets. Glad to know that you really like the 327. This is my first time to own one. Heck, this is my first time to even hold one!

Thanks everybody for your thoughts. I really appreciate you taking the time to post and help me out here. In the past I have loaded mostly jacketed pistol bullets but I want to try my hand at cast bullets now. I think for the velocity I am looking for (1000+fps) I will give Acme bullets a...

Just bought a Ruger Single Seven 5.5" and I am looking for a good cast bullet to load. I would like to push it around 1100--1200 fps. Any and all recommendations are very much appreciated! Oh one more thing--has anyone had any experience with Acme coated bullets? Thanks, hs

Absolutely Beautiful!!! Just simply BEAUTIFUL!!!

Absolutely beautiful!!! Thanks for posting!

Upon further research, the reloading data center at the Hodgdon Powder Co. website specifically calls for a WSPMagnum primer for this very bullet when using Titegroup powder. Furthermore, it calls for a Titegroup powder load of between 4.5 grains (starting load) and 5.0 grains (maximum grains)...

THANKS FOLKS!!!! All of you helped me very much. You got me pointed in the right direction and I appreciate it!! I hope I can help each one of you one day. hs

I am trying to load some 357 magnum 158 grain Oregon Trail SWC cast bullets. I will be using 4.2 grains of Titegroup powder. For that powder my load data says to use from a minimum of 3.8 grains up to a maximum of 4.4 grains so I am well within the powder range recommended. The load manual...

THANKS to all of you for sharing that information. I have been loading jacketed bullets (on and off) for close to 15 years but recently have wanted to try lead bullets. I really appreciate all the suggestions and advice! You have helped a lot!! hs

Can anyone please give me some load data for the following Cast Performance Bullet? I will be using this load in my Ruger Super Blackhawk 44 magnum 4.62” barrel revolver and would prefer only those loads that shouldn’t lead my barrel. Revolver: Ruger Super Blackhawk 44 magnum Bullet Cal...