Recent content by Cessnaflyer

Numrigh Gun Parts. http://www.gunpartscorp.com/

I like to see pictures of the striker and where it broke. That's a pretty hefty striker. I have two of the SR series and both have the rocket and I dry fire practice quite a bit..

You have a PM.

OK - I have and SR9c that is hanging up when the slide is retracted by about 3/8 inch from battery. It seems to be getting a little worse. I am assuming this is because of the trigger bar reset when retracting the slide. A little extra force will force the slide to fully retract to the rear...

If you don't like them and you have a Dremil with a cutoff wheel just cut the end off and you have an inspection port similar to the 9E. The slot in the slide is filled so no holes in the slide. If you change you mind you can order them thru Ruger and simply replace it by driving out the...

It has the advantage of being able to change spring weight if needed. I purchased the 20lb spring. No problem with any ammo I tried. It is noticably harder to rack and would probably be a problem for my wife if it were her gun.

I have them on two Berettas and think they are "sometimes" an advantage for problems like your night vision issue. When the adrenaline starts flowing and the pressure is increasing then any advantage is good. Crimson Trace provides a training CD and suggest you review it if you can get it...

My SR9c did that except it happened for every other round regardless of mag or ammo used. I wasn't about to repair a brand new gun that should have never left the manufacturer in that condition. Ruger decided it could not be repaired and replace the firearm and the new one has been 100%...